Weighing With Tolerance Range - KERN and SOHN PNJ Mode D'emploi

9.3 Weighing with tolerance range

Using the application „Weighing with tolerance range" you can set an upper or lower
limit value and thus ensure that the weighed load remains exactly within the set
tolerance limits.
Limit value inputs are possible at the functions weighing, parts counting and
percentage determination.
There are two different ways to set the tolerance limits:
1. By weighing, that is by placing item on weighing balance and saving this value
as nominal weight, see chap. 9.3.2
2. Numeric input of nominal values via keyboard, see chap. 9.3.3
Display of the results:
The triangular tolerance marker [ ] in the display of the display shows whether the
goods to be weighed are within the two tolerance limits. The tolerance mark is only
visible when function „2.SEL 1" is enabled (see chap. 9.3.1).
The tolerance mark provides the following information:
1. Menu setting „23.Pi. 2" / two limit values
Load below specified tolerance
Load within specified tolerance
Load exceeds specified tolerance
2. Menu setting „23.Pi. 1" / one limit value
Weighing good < Target weight
Target weight reached
Weighing good > Target weight
46
No information
PNJ_PNS-BA-e-1612