KERN and SOHN PNJ Mode D'emploi page 126

48
Use the TARE-key to select the desired setting
„22.Li. 0" The tolerance mark is only displayed
above zero range (> 5 d).
„22.Li. 1" Tolerance marker is displayed for the
whole range.
Use the F-key to select the next menu item "23.Pi. for
setting the number of limit points.
Use the TARE-key to select the desired setting
1- Limiting point (OK/ -)
„23.Pi. 1"
2- Set the limit point as lower and upper
„23.Pi. 2"
limit (+ / OK / -)
Save / back to weighing mode:
Confirm settings with SET-key. The balance returns into
the tolerance weighing mode
PNJ_PNS-BA-e-1612