Weighing With Tare; Weighing With Tolerance Range - KERN and SOHN SFB 10K1HIP Mode D'emploi

7.6 Weighing with tare

 Deposit weighing vessel. After successful stop check press the
The zero display and the indicator
The weight of the container is now internally saved.
 Weigh the material, the net weight will be indicated.
 The weight of the weighing container will be displayed as a minus number after
removing the weighing container.
 The tare procedure can be repeated as many times as necessary, for example
with initial weighing of several components for a mix (add-on weighing). The limit
is reached when the taring range (see type plate) capacity is full.
 Switch between gross weight and net weight by pressing the
 To delete the tare value, remove load from weighing plate and press
7.7

Weighing with tolerance range

You may determine an upper and lower limit for weighing with tolerance limits in
order to ensure that the weighed load remains exactly within the fixed tolerance
limits.
During tolerance checks such as dispensing, portioning and sorting, the instrument
will indicate any lower deviation or exceeding of limits with the help of a visual signal
or audio sound.
Acoustic signal:
The audio sound depends on the setting of the menu block "BEEP".
Options:
• no
Acoustic signal turned off
• ok
Acoustic signal sounds when load is within tolerance
limits
• ng
Acoustic signal sounds when load is beyond tolerance
limits
30
NE T
appear.
button.
key.
.
SFB-BA-e-1625