Angelcare AC115 Manuel Du Propriétaire page 13

TO STOP THE ALARM
Place your hand back
on the mattress.
5.3 - PAUSING AND RESTARTING THE SENSOR PAD
Allows you to pause the Sensor Pad if you remove baby from the crib, e.g. for feeding or comforting.
Pause/Unpause Sensor Pad
IMPORTANT
• If you do not pause the Sensor Pad, the alarm will sound if there is no movement detected on the surface of
the mattress after 20 seconds.
• Ensure to unpause the Sensor Pad before putting back in the crib.
5.4 - ADJUST THE SENSOR PAD SENSITIVITY LEVEL:
To ensure adequate monitoring of your baby's movements, you can adjust the sensitivity of the Sensor Pad. Set a high
sensitivity for a newborn and a lower sensitivity as baby grows and gains weight. A thicker mattress will also need a higher
sensitivity. Slide the Nursery Unit sensitivity level button to select between low, medium or high level.
For optimal results begin with medium sensitivity
level, adjusting the sensitivity by increasing or
decreasing if required.
NOTE:
If you are experiencing false alarms, adjust the
sensitivity level.
OR
Press PAUSE button on the
Nursery Unit
OR
1) From the Parent Unit, press and hold
Pause Sensor Pad button for at least
2 seconds.
OR
From the Nursery Unit, press
the Pause button.
2) To unpause the Sensor Pad, from the
Parent Unit, press the Pause Sensor
Pad button (OK button)
OR
From the Nursery Unit, press
the Pause button.
E
Press any
N
button on the
Parent Unit.
13