Angelcare AC115 Manuel Du Propriétaire page 7

2
Sensor Pad
4
6
3'' (8 cm)
7
CLICK!
4
8
4
3
3
5
6
5
3 2
9
2
1
1) Remove the mattress from
4
3
2) Place the Sensor Pad –
2
1
3) Run the connection pin, warning
4) Bring the first 4 cord covers
5) Remove any cord slack to
6) Place the 6
7) Snap together the remaining
1
8) Remove any cord slack to
9) Peel off the double-sided
the crib.
Angelcare logo side up – on
®
top of the hardboard.
label and the first 5 cord covers
down along the rear of the crib
leg, between the mattress
support and the inside edge
of the crib.
down the floor, and keep
the 5 cord cover vertically,
th
along the rear of the crib leg,
between the mattress
and the inside edge of
the crib.
make sure no parts of the
cord are loose.
cord cover
th
approximately 3'' (8 cm)
from the edge of the
mattress support.
cord covers that will run along
the floor.
make sure no parts of the
cord are loose.
tape on the 4 cord cover
th
and place it securely under
the crib leg.
E
N
7