Before First Time Use; Setting Up The Nursery Unit - Angelcare AC115 Manuel Du Propriétaire

IMPORTANT!
SECURELY PLACED UNDER THE LEG OF THE CRIB
• NEVER attempt to use the Sensor Pad(s) cord without the protective cord covers supplied.
• Ensure the Sensor Pad cable connector is locked into the Sensor Pad – check before each use.
• Ensure the Sensor Pad is in the center of the Crib – printed or Logo side up – on top of the
hardboard. Check the position is central before each use.
• When re-positioning the mattress support as your child grows, adjust the position of the
vertical cord cover (on the leg of the crib) by threading the cord through the cover and ensure
the cover is always vertically central about the leg. Remove any slack in the cord.
• BEFORE FIRST TIME USE: Test that the unit is ready for use – refer to to the Full User Manual
to check installation is correct.
STEP 3 - SETTING UP THE NURSERY UNIT
Select a location for the Nursery Unit that is at least 3 feet (1 meter) away from the crib.
6
Sensor Pad
5
8
ENSURE THE CORD PROTECTIVE COVER IS
1
2
MUST BE AT LEAST
3 FEET (1 METER) DISTANCE
5
4 3 2 1
1) Remove the batteries cover and insert
2 AAA Alkaline Batteries (not included)
Note:
• The batteries are a back up power
supply in case of power outage.
• When unplugging the adapter
from the Nursery Unit, be sure it is
switched to the OFF position. If it
isn't, the unit will revert to battery
mode if batteries are installed.
2) Install the Nursery Unit on a flat, stable
surface facing the crib at a distance of
at least 3 feet (1 meter) and plug the
Sensor Pad cord into the Nursery Unit.
3) Check to make sure the Sensor Pad has
not moved from its position.
4) Place the mattress back inside the crib.
5) Connect the USB plug to the Nursery
Unit and the USB plug with the power
adapter and then to an electrical outlet.