Inlet - Cooper Crouse-Hinds CEAG GHG 57 Mode D'emploi

Fig. 5
A Individuell parts
B Crimping
B Positioning - PE-clamp
C Complete pins and contact sockets
with inlet or flange socket insert
Time code 6h
D Assemble with inlet or flange socket
sleeve
E Keyway of inlet or flange socket in
sleeve
Cooper Crouse-Hinds GmbH
22
Exposion-protected plug and socket systems
5-pole (4+PE) / 4-pole (3+PE), GHG 57.
nlet (Ex-e) – Moulded plastic nlet (Ex-e) – Moulded plastic
6.2.1.3 Inlet (Ex-e) – Moulded plastic nlet (Ex-e) – Moulded plastic nlet (Ex-e) – Moulded plastic
5-pole (4+PE)
Connection in acc. with Fig. 5, A - E:
1. First, together with the insulating
sleeve, Item 7, push the inlet insert, Item 14,
forwards out of the plug sleeve, Item 17.
2.
Remove the plug pins from the
packa-ging and then, using the special
crimping tool (available under Order No. GHG
5901902 R0001). Crimp the stripped
connection wires (ca. 8 / 5mm) of the
connection cable onto the plug pins, Item 13,
and the PE connection lug, Item 9, (previously
removed from the inlet insert).
Optionally, these pin connections can be
soldered on. The soldered joint shall be
protected additionally with a shrink-on
sleeve.
3.
After having crimped / soldered on
the connection cable, push the plug pins into
the inlet insert, Item 14, from the back until
reaching the stop (with normal manual
strength in consideration to hexagon guide).
Warning: Once they have been pushed
into the inlet insert, the pins cannot be
dismantled again.
Coupler
rear
PE- clamp (9)
3.
6.2.1.3 Inlet (Ex-e) – Moulded plastic nlet (Ex-e) – Moulded plastic nlet (Ex-e) – Moulded plastic nlet (Ex-e) – Moulded plastic nlet (Ex-e) – Moulded plastic
4-pole (3+PE)
Connection in acc. with Fig. 5, A - E:
Assembly of 4-pole inlets as for 5-pole
version, but without PE clamp, Item 9.
4. Now the insulating sleeve, Item 7, can
be pushed in to the correct position over the
connection cable and onto the inlet insert,
Item 14.
5. Now press the PE lug into the recess
in the inlet insert and push it into the groove
on the front of the inlet insert until it engages.
6. Finally, push the complete inlet insert,
connection lead first, through the inlet sleeve,
Item 17, from the front and press it in the
correct position until it engages (see also Fig.
5, A-E).
The inlets may only be used in enclosures
in the type of protection Ex-e.
Coupling nut (16)
4.
1.

Inlet

insert (14)
Plug pins (13)
Instead there is a leading PE pin for setting
the respective time code (h) of the plug and
socket components.
Coupling nut (16)
3.
1.
Inlet
insert (14)
Plug pins (13)
Inlet
sleeve (17)
2.
Insulating sleeve (7)
Inlet
sleeve (17)
2.
Insulating sleeve (7)