Charging The Battery; Seat And Ground Speed Lever Adjustments - Briggs & Stratton 360Z XT Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Charging The Battery

WARNING
Explosion and Fire Hazard
Keep open flames and sparks away from the battery; the
gasses coming from it are highly explosive. Ventilate the
battery well during charging.
A dead battery or one too weak to start the engine may be
the result of a defect in the charging system or other electrical
component. If there is any doubt about the cause of the
problem, see your dealer.
To charge the battery, follow the instructions provided by the
battery charger manufacturer as well as all warnings included
in the Operator Safety section of this manual. Charge the
battery until fully charged. Do not charge at a rate higher than
10 amps.
Seat And Ground Speed Lever
Adjustments
The seat and ground speed levers should be adjusted so
that the ground speed levers can be moved through their full
range of motion without contacting the operator's legs.
Seat Adjustment
The seat can be adjusted forward and back. Move the lever
(A, Figure 18) towards the left, position the seat as desired,
and release the lever to lock the seat into position.
18
Ground Speed Lever Adjustment
1. Loosen the ground speed lever mounting hardware (A,
Figure 19) to adjust the levers forward and backward.
2. Remove the hardware to raise or lower the levers.
3. Always be sure to adjust both levers so that they are
aligned (B, Figure 19).
4. After adjustment is complete, tighten the hardware to 13
lb-ft (18 Nm).
19
Speed Balancing (Tracking) Adjustment
If the rider drifts to the right or left when the ground speed
levers are in the maximum forward position, the top speed of
each of these levers can be balanced. Only adjust the speed
of the wheel that is traveling faster. 
1. Tighten the knob (A, Figure 20) of the faster wheel by 1/2-
turn (clockwise) increments until the rider travels (tracks)
straight.
WARNING
 Unsafe Operation Hazard 
DO NOT adjust the rider for a faster overall speed
forward or reverse than it was designed. 
15

Publicité

Table des Matières
loading

Table des Matières