Mower Removal And Installation; Mower Deck Leveling - Briggs & Stratton 360Z XT Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

20

Mower Removal And Installation

Refer to the Mower Deck Manual for instructions on removing
and installing the mower deck.

Mower Deck Leveling

Refer to the Mower Deck Manual for instructions on leveling
the mower deck.
Changing the Engine Oil and Filter
This series of mower has different engine options: Briggs &
Stratton Commercial Turf (A, Figure 21) and Kawasaki FR
Series (B). Please reference figure 21 as the location of the
components listed for this procedure may vary by specific
engine option.
16
21
1. Warn the engine by running it for a few minutes. (Refer to
the engine operator's manual for oil and filter replacement
instructions.)
2. Remove the oil drain hose (C) from it's storage position
and route the hose so that when the oil drain cap is
removed the oil can be drained into a small pan.
3. Place a small pan under the oil drain hose to catch the oil.
Using the appropriate tools, remove the oil drain cap from
the oil drain hose and drain the engine oil.
4. After draining, replace the cap and wipe up any spilled oil.
Reinstall the oil drain hose to its storage position so it is
retained during normal operation.
5. Place an absorbent shop cloth under the engine oil filter
(D). Remove the engine oil filter and replace with a new
one.
6. Add engine oil (refer to engine operator's manual) in the
fill tube (E) and check the amount of oil in the engine
using the engine oil dipstick (F).
7. Remove the shop cloth and wipe up any spilled oil.
Air Filter Assembly (Cyclonic with pre-
cleaner)
WARNING
DO NOT start or operate the engine with the air cleaner
assembly or air filter removed as it is a fire hazard. 
NOTICE
Do not use pressurized air or solvents to clean the filter.
Pressurized air can damage the filter and solvents will
dissolve the filter. 

Publicité

Table des Matières
loading

Table des Matières