Towed Equipment - Briggs & Stratton 360Z XT Manuel D'utilisation

As you become more familiar and experienced with operating
the Zero Turn rider, you will learn more maneuvers that will
make your mowing time easier and more enjoyable.
Remember, the more you practice, the better your control
of the Zero Turn will be!
Mowing
1. Make sure that the PTO switch is disengaged, the parking
brake is engaged, the ground speed control levers are
locked in their START/PARK positions, and the operator
is in the seat.
2. Start the engine. See Starting the Engine.
3. Set the mower cutting height. See Cutting Height
Adjustment.
4. Set the engine speed control to FAST.
5. Disengage the parking brake.
6. Engage the PTO by pulling up on the PTO switch.
7. Move the ground speed levers in from the START/PARK
position to the neutral 'N' position.
8. Begin mowing. See Operator Safety for tips on safe
mowing practices.
9. When finished, shut off the PTO.
10. Stop the engine. See Stopping The Rider and Engine.

Towed Equipment

Secure the trailer with an appropriately sized clevis pin (A,
Figure 13) and clip (B). See Operator Safety for additional
safety information regarding trailers and towing.
WARNING
Towing Hazard
Towed loads can be hazardous and cause loss of control
on slopes.
• The max gross (trailer & load) weight of trailer is 200 lbs
(91kg).
• Do not operate on slope exceeding 5 degrees.
• Reduce speed and use extreme caution on slopes.
12
13
Cutting Height Adjustment (Pin Type)
The cutting height adjust pedal adjusts the mower cutting
height. See Specifications for cutting height adjustment
range.
To adjust cutting height:
1. Fully depress the cutting height adjust pedal (A,
Figure 14) until the transport release rod (B) locks the
deck into the highest position (transport position).
2. Remove the pin (C, Figure 14) from the adjustment
bracket, and insert it in the desired hole.
Note: Make sure the pin is inserted into the holes in both
upper and lower plates of the adjustment bracket.
3. Depress the cutting height adjust pedal, move the
transport release rod outward, and slowly release the
pedal until it rests against the pin.
14
C
B
A