Check The Spark Plugs; Pushing The Rider By Hand - Briggs & Stratton 360Z XT Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Loosen the fasteners (A, Figure 22) and remove the
cover (B).
22
2. Open the latch (C) and remove the air filter assembly
(D).
3. Remove the pre-cleaner (E) from the air filter.
4. To loosen debris, gently tap the air filter on a hard
surface. If the air filter is dirty, replace it with a new air
filter.
5. Wash the pre-cleaner in liquid detergent and water. Then
let it thoroughly air dry. Do not lubricate the pre-cleaner.
6. Assemble the dry pre-cleaner to the air filter.
7. Install the air filter assembly and close the latch.
8. Install the cover with the fasteners.

Check the Spark Plugs

WARNING
Unintentional sparking can result in fire or electric shock. 
Unintentional start-up can result in entanglement, traumatic
amputation, or laceration. 
 When testing for spark: 
• Use approved spark plug tester.
• Do not check for spark with spark plug removed.
NOTICE
Spark plugs have different heat ranges. It is important that
the correct spark plug is used, otherwise, engine damage
can occur. Replace the spark plug with the same type or
equivalent one. 
Clean Spark Plug 
Clean the spark plug with a wire brush and sturdy knife. Do
NOT use abrasives. 
Check Spark Plug Gap 
Use a spark plug feeler gauge (A, Figure 23) to check the
gap between the two electrodes. When the gap is correct, the
gauge will drag slightly as you pull it through the gap. 
To adjust the spark plug gap, use a spark plug gauge and
gently bend the curved electrode. Make sure that you do not
touch the center electrode or the porcelain.  
23
Install Spark Plug 
Tighten the spark plug with your fingers, and then, tighten it
with a wrench as shown in Figure 24. 
• 180 in-lbs (20 Nm), OR
• 1/2 turn when you install the original spark plug. 1/4 turn
when you install a new spark plug.
24

Pushing the Rider By Hand

WARNING
 Unsafe Operation Hazard. 
DO NOT disengage the transmissions and coast down
slopes. DO NOT use Roll Release to disengage the
transmissions unless machine motion can be controlled and
engine is off. 
NOTICE
 Do not tow rider. Towing the unit will cause transmission
damage. Do not use another vehicle to push or pull this
unit. 
17

Publicité

Table des Matières
loading

Table des Matières