Troubleshooting; Troubleshooting The Rider - Briggs & Stratton 360Z XT Manuel D'utilisation

1. Disengage the PTO, lock the ground speed levers into
their START/PARK positions, turn the ignition OFF,
remove the key, and wait for all moving parts to stop.
2. To disengage the transmissions, move the roll release
levers (A or B, Figure 25, depending on model), into the
PUSH position as shown.
3. Pivot the ground speed levers in from the START/ PARK
position to the neutral 'N' position to disengage the
parking brake. The rider can now be pushed by hand.
4. After moving the rider, re-engage the transmissions
by moving the roll release levers back to the DRIVE
position.
25
Cleaning
1. Clean dirt and debris from the rider and mower deck.
Note: Some mower decks feature a washout port. See
Washing The Mower Deck .
2. Clean any debris buildup in the engine compartment and
from on or around the engine.
WARNING
Fire Hazard
18
Yard debris is combustible.
• Clean dirt and debris from the rider and mower deck.
• Clean build-up from around the engine.
Storage
WARNING
Fire and Explosion Hazard
Never store the unit (with fuel) in a closed structure without
sufficient airflow. Fuel vapors can travel to an ignition
source (such as a furnace, water heater, etc.) and cause an
explosion. Fuel vapor is also toxic to humans and animals.
When Storing Fuel Or Equipment With Fuel in Tank
• Store away from furnaces, stoves, water heaters, or
other appliances that have pilot lights or other ignition
sources because they can ignite fuel vapors.
Equipment
Disengage the PTO, lock the ground speed levers in the
START/PARK position, and remove the key.
Battery life will be increased if it is removed. Put in a cool, dry
place and keep fully charged during storage. If the battery is
left in the unit, disconnect the negative cable.
Engine Oil
While the engine is still warm, change the engine oil.
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Do all recommended checks and procedures found in this
manual.
• Let the engine warm up for several minutes before use.
Storage - Fuel System
Fuel can become stale when kept in a storage container for
more than 30 days. Each time you fill the container with fuel,
®
add STA-BIL 360° PROTECTION™ to the fuel as specified
by the manufacturer's instructions. This keeps fuel fresh and
decreases fuel-related problems or contamination in the fuel
system.
It is not necessary to drain fuel from the engine when STA-
®
BIL 360° PROTECTION™ is added as instructed. Before
storage, turn the engine ON for 2 minutes to move the fuel
and stabilizer through the fuel system.

Troubleshooting

Troubleshooting The Rider

PROBLEM LOOK FOR
Engine will not turnover Ground speed levers
or start. not in START/PARK
positions.
PTO (electric clutch)
switch in ON position.
Out of fuel.
REMEDY
Lock ground speed
levers in START/ PARK
positions.
Place in OFF position.
If engine is hot, allow
it to cool, then refill the
fuel tank.