Check Mower Blade Stopping Time
WARNING
If the mower blade does not come to a complete stop
within 5 seconds, the blade must be adjusted. Do not
operate the machine until the proper adjustment has been
performed by an authorized dealer.
Mower blades and mower drive belt should come to a
complete stop within five seconds after the electric PTO
switch is turned off.
Check the mower blade for proper function (see Safety
Interlock System Tests). The blade should stop rotating in
5 seconds or less after moving the blade control to the OFF
position.
Cleaning the Battery and Cables
WARNING
Battery posts, terminals, and related accessories contain
lead and lead compounds - chemicals known to the
State of California to cause cancer, birth defects, or other
reproductive harm. Wash hands after handling.
1. Disconnect the cables from the battery, negative cables
first (A, Figure 9) then the cover and positive cables (B).
2. Loosen the wingnut and washer (D).
3. Pivot the hold-down rod (C) up and away from battery.
Secure to steering tower.
4. Remove the battery (E).
5. Clean the battery compartment with a solution of baking
soda and water.
6. Clean the battery terminals and cable ends with a wire
brush and battery terminal cleaner until shiny.
7. Reinstall the battery in the battery compartment.
Secure with the battery hold-down rod and wingnut
and washer.
8. Re-attach the battery cables, positive cables and cover
first then the negative cables.
9. Coat the cable ends and battery terminals with
petroleum jelly or non-conducting grease.
D
C
Figure 9
A
B
E
Charging the Battery
WARNING
Keep open flames and sparks away from the battery; the
gases coming from it are highly explosive. Ventilate the
battery well during charging.
A dead battery or one too weak to start the engine may
be the result of a defect in the charging system or other
electrical component. If there is any doubt about the cause
of the problem, see your dealer. If you need to replace the
battery, follow the steps under Cleaning the Battery and
Cables.
To charge the battery, follow the instructions provided by
the battery charger manufacturer as well as all warnings
included in the safety rules sections of this book. Charge
the battery until fully charged. Do not charge at a rate higher
than 10 amps.
Seat Adjustment
The seat can also be adjusted forward and back. Move
the lever (A, Figure 10), position the seat as desired, and
release the lever to lock the seat into position.
Figure 10
A
en
19