Fuses Replacement; Cleaning The Device; Inspecting The Cables; Extraordinary (To Be Done Only Under Particular Circumstances) - Videotec MAXIMUS MHX Manuel D'instructions

10.1.1.4 Fuses replacement

Maintenance must be performed with the
power supply disconnected.
If necessary, the connector board's fuse can be
replaced. The replacement fuse must comply with the
directions given in the table.
FUSES REPLACEMENT
Voltage
12Vdc
24Vac, 50/60Hz
120Vac, 50/60Hz
230Vac, 50/60Hz
Tab. 11
FUS1
Fig. 48
Version without power supply.
Fig. 49
Version with power supply.

10.1.1.5 Cleaning the device

This should be done regularly. If a layer of dust
accumulates on the outside of the housing, it should
never be more than 5mm thick. The device should be
cleaned using a damp cloth; compressed air must not
be used. Maintenance frequency will depend on the
type of environment in which the housing is used.

10.1.1.6 Inspecting the cables

The cables should not show signs of damage or wear,
which could generate hazardous situations. In this
case extraordinary maintenance is necessary.
36
Fuse (FUS1)
T 4A H 250V 5x20
T 4A H 250V 5x20
T 1A L 250V 5x20
T 1A L 250V 5x20
FUS1
10.1.2 Extraordinary (to be done only
under particular circumstances)
Any other intervention that is not
comprised in the routine interventions
must be done in absence of potentially
explosive atmosphere.
For damage to any parts, repair or
replacement must be done by, or under
supervision of VIDEOTEC.
Whenever replacing the parts as indicated,
always use VIDEOTEC original spare parts
and meticulously follow the maintenance
instructions supplied with every spare parts
kit.
The manufacturer declines all liability for
damage to any of the apparatus mentioned
in this handbook, when resulting from
tampering, use of non-original spare parts,
and from installation and maintenance/
repairs performed by non-authorised, non-
skilled personnel.
In all such circumstances, the product
should be sent to the workshop for the
necessary repairs or maintenance.
MNVCMHX_1432_EN