Honeywell IAQPoint2 Guide De Démarrage Rapide page 43

Configure\Configure Display
Configure Display
Main Disp. Dataset
Idle Behavior: Dim
Temp. Units: F
Easy Temp Adj: Off
Temp Units is available only for monitors with temperature/humidity sensors�
Easy Temp Adj is available for digital monitors and those fitted with temperature/
humidity sensors�
Configure\Display\Main Display Dataset
Main Display Dataset
CO2 Graphics
CO2 Numeric
Temperature
Relative Humidity
Occupied Status
How much information is displayed on the home screen is determined at this
screen� For example, some users may choose to disable the display of some
information for simplicity and less distraction� In some installations, it may be
preferable to disable the CO
permissible (including, if desired, none of them)� The default selections are Gas
Graphic, Gas Numeric, Temperature, Relative Humidity, and Occupied Status�
(Temperature and Relative Humidity are available in monitors with the temperature/
humidity sensor�)
Configure\Display\Idle Display Behavior
To conserve energy, if the screen has not been touched for five minutes, the
monitor will revert to the home screen and, depending on the selection made at the
Idle Display Behavior screen, will either dim or go off� Off is the default selection�
There is no setting to keep the display at full brightness or to persist on the menu
screen without touching�
Configure\Display\Temp. Units
Whether temperatures are displayed in degrees Fahrenheit or degrees Celcius is
controlled from this screen� The default is Fahrenheit� This screen is available only
on models with the optional temperature/humidity sensor�
reading� Any combination of the five outputs is
2
IAQPoint2™
37