Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Wall Mount Installation
Wall Mount Installation
The converter should be mounted on a wall where there is minimum
vibration, away from heat and with sufficient ventilation room around
the unit. Its location should be within easy reach of operating
personnel.
301ADI
Mounting Instructions
1. Select installation location
2. Measure and mark mounting holes (as shown)
3. Pre-drill or prepare as required by mounting surface (drywall plugs,
etc.)
4. Position unit and align mounting holes with markings and install
necessary screws.
Note: Remember to remove knock-outs before mounting the unit.
14
26.8 cm
(10 9/16")
301ADI User Manual
Honeywell
Power
Fault
TX
Analog Digital Input Converter
301ADI
16.4 cm
(603/8")
510846
4/07
Publicité
Chapitres
Table des Matières
Dépannage
