Programming Functions - Honeywell IAQPoint2 Guide De Démarrage Rapide

Using the Transmitter

Programming Functions

Programming Functions
There are several numbered
functions (pushbutton
sequences) that can be
performed directly on the
transmitter. Pushbuttons are
located in the area directly
below the LEDs; Pushbutton
1 is located below LED 1,
pushbutton 2 is located below
LED 2. This section provides
instructions on how to
perform each of these
functions.
Pushbutton 1 is used as the
access and Enter (or
confirmation) button, while
pushbutton 2 is used to select
commands. When selecting
a command function, you
must hold pushbutton 2 and
count the blinks (one for pushbutton activation and the number of times
representing the function number: For function 2, you must count 3
blinks; function 3, count 4 blinks, etc).
After each command selection, the LEDs will blink the command
number for 3 cycles to confirm the command (and give you the
opportunity to cancel). After the 3 cycles, the unit will execute the
command.
Example: You have selected command 7 (adjust sensor zero): LED 1
will blink 7 times, three times before executing the command.
You can cancel the command at any point before the end of
the third cycle (see Cancelling All Commands).
22 301W User Manual
Honeywell
511398
5/07