Important - Fox 32 FLOAT Mode D'emploi

ADJUST THE QUICK RELEASE (AWL, 36, AND 38 FORKS)
1. Note which direction the axle lever needs to turn to achieve proper
orientation.
2. Open the axle lever in the fork.
3. While holding the QR lever open and stationary so it cannot rotate, use
a 4 mm hex wrench in the center of the end of the axle to adjust the
lever position. With the 4 mm adjuster set properly, you should start
to feel tension in the axle when the QR lever is 90 degrees before full
closure in the vertical position.
4. Repeat the axle installation instructions to verify proper installation and
adjustment.
KABOLT INSTALLATION (AX, 32, 34, AND 36 RHYTHM FORKS)
Wheel installation is identical for the 15x100 mm,
15x110 mm, and 12x100 mm Kabolt axle.
IMPORTANT: The Kabolt designed for the 2022 32 and
34 forks, along with the 2021 36 Rhythm fork, is not
compatible with the 2022 36 and 38 forks.
1. Install the front wheel into the fork dropouts. Slide the
Kabolt axle through the non-drive side dropout and hub.
2. Use a 6 mm (5 mm for AX forks) hex wrench to torque
the Kabolt axle (clockwise) to the torque specification
that is etched on the head of the Kabolt.
KABOLTX INSTALLATION (36 AND 38 FORKS)
IMPORTANT: The KaboltX is only compatible with the
2021+ 36 and 38 forks.
1. Loosen the pinch bolt, then install the front wheel into
the fork dropouts. Slide the KaboltX axle through the
drive side dropout and hub.
2. Use a 6 mm hex wrench to torque the KaboltX axle
clockwise to the torque specification that is etched on
the head of the Kabolt.
3. Compress the fork a couple of times to ensure that the
lower leg has settled into its low-friction point.
4. Tighten the pinch bolt on the drive side dropout to
5.1 N-m (45 in-lb) torque.
Pinch Bolt
8