Assembly & Installation - PRO-POINT 8784720 Mode D'emploi

8784720
IDENTIFICATION KEY
A Upper Tong
B Electrode Tip
C Lower Tong
D Wood Handle
E Front Jam Nut
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included
Identification Key.
IMPORTANT! The 240V Spot Welder comes equipped with a
power supply cord only. A 240V plug must be installed by a
qualified electrician to match your outlet configuration and
power supply.
The wood handle (D) is optional if the tool remains in a
stationary location. Insert the screws into the housing to prevent
the screw holes from becoming dirty.
14
220V SPOT WELDER
F Spatter Guard
G Rear Jam Nut
H Hex Nut
I Operating Lever
J Cap Screw
For technical questions call 1-800-665-8685
K Handle
L Power Switch
(not visible)
M Housing
V1.0
Fig. 1