Troubleshooting & Repair; For Further Troubleshooting And Repair - MINN KOTA Terrova Manuel De L'utilisateur

TROUBLESHOOTING & REPAIR
CAUSE
Remote is not transmitting.
When receiver is powered up, it sounds a
beep pattern (1 long beep, 2 short beeps,
pause, repeat).
The prop is not turning but the PROP ON
audio tick is still going.

FOR FURTHER TROUBLESHOOTING AND REPAIR

We off er several options to help you troubleshoot and/or repair your product. Please read through the options listed below.
FREQUENTLY ASKED QUESTIONS
We have FAQs available on our website to help answer all of your Minn Kota questions. Visit minnkotamotors.com and click on
"Frequently Asked Questions" to fi nd an answer to your question.
CALL US (FOR U.S. AND CANADA)
Our consumer service representatives are available Monday – Friday between 7:00 a.m. – 4:30 p.m. CST at 800-227-6433.
If you are calling to order parts, please have the 11-character serial number from your product, specifi c part numbers, and credit
card information available. This will help expedite your call and allow us to provide you with the best consumer service possible.
You can reference the parts list located in your manual to identify the specifi c part numbers.
EMAIL US
You can email our consumer service department with questions regarding your Minn Kota products. To email your question, visit
minnkotamotors.com and click on "Support".
AUTHORIZED SERVICE CENTERS
Minn Kota has over 300 authorized service centers in the United States and Canada where you can purchase parts or get your
products repaired. Please visit our Authorized Service Center page on our website to locate a service center in your area.
©2015 Johnson Outdoors Marine Electronics, Inc.
EFFECT
The battery is discharged.
Receiver may not have "learned" the ID
number of the remote.
With the foot pedal connected, the MOM-
CON switch is in the CON position. An audio
response will be heard if a button is pressed
with the foot pedal in the CON position.
If remote has been taken apart, the keypad
and top case may have been installed
backwards.
The foot pedal MOM-CON switch is in the
CON position.
Prop Speed is set at "0".
PROP ON tick occurs only in Audio Mode 3
SOLUTION
Replace battery.
Remote needs to be learned. See "Adding/
Removing Remotes" to learn the remote ID
number.
The foot pedal switch must be placed in the
MOM position. The receiver will not accept
any commands from the remote with the
switch in the CON position.
Take remote apart (see "Replacing the
Battery") and reinstall case halves with the
proper orientation.
The foot pedal switch must be placed in
the MOM position. The beeping sound will
continue until the switch is placed in the
MOM position.
Increase the prop speed above "0"
Switch Audio Mode to either Audio 1 or 2.
See "Audio Modes".
minnkotamotors.com | 11