Explosion Hazard - Allmand NIGHT-LITE V Serie Manuel D'utilisation

3. Disconnect the red positive (+) battery cable (B, Figure
29) from the postive (+) battery terminal, and secure
away from the battery.
4. Loosen the hardware securing the battery hold-down (C,
Figure 29), and remove the hold-down.
5. Carefully remove the battery, and place in a well-
ventilated area on a level surface.
To install the battery
1. Carefully place the battery in the engine compartment
with the battery terminals toward the front of the unit.
2. Install the battery hold-down on top of the battery. Tighten
the hardware securely.
3. Connect the red positive (+) battery cable(s) to the
positive (+) battery terminal.
4. Connect the black negative (-) battery cable(s) to the
negative (-) battery terminal.
WARNING

Explosion Hazard

Failure to install the black negative (-) battery cable(s) last
could cause sparks and/or an explosion resulting in death
or serious injury. Always install the black negative (-) battery
cable(s) last.
5. Replace the terminal covers over the battery terminals.
6. Close and latch the engine compartment cover.
29
Cleaning
WARNING
Entanglement Hazard
Failure to shut down the engine before cleaning the unit
could result in death or serious injury. Always shut down the
engine before cleaning the unit.
28
WARNING
Burn Hazard
Shut down the engine and lights and allow ample time for
components to cool before cleaning the unit. Failure to do
so could result in serious burns.
NOTICE
Use caution when using compressed air or water / steam
pressure washers. Do not pressure–clean electrical
components, as this may cause damage.
Keeping the light tower clean is important to ensure proper
operation. Dirt and dust buildup acts as an insulator and may
cause the engine, generator and light assemblies to operate
at excessively high temperatures.
Use the following as cleaning guidelines:
1. Clean the light tower trailer to remove all dust, dirt or
other foreign material.
2. Clean the light tower and light fixture assemblies with a
damp cloth or sponge.
3. Clean all electrical wiring and components by hand using
non-corrosive cleaner.
4. Clean the inside of the engine compartment.
5. Clean any oil or liquid spills inside the engine
compartment.
6. Empty the fluid containment tray. See Draining the Fluid
Containment Tray.
Models and Serial Numbers
Model and serial number information is required for product
support and repair parts. Following are the model and serial
number locations of the primary components.
Trailer
The serial number plate for the light tower trailer is located
on the left side of the unit above the front forklift pocket (A,
Figure 30).
30
Generator
The generator has a serial number plate (A, Figure 31 or 32)
attached to the top of the housing.
www.allmand.com