Fueling The Unit - Allmand NIGHT-LITE V Serie Manuel D'utilisation

Masquer les pouces Voir aussi pour NIGHT-LITE V Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

the rear of the machine, and reinstall, making sure the pin
locks the outrigger in the operating position.
3. Remove the stabilizer jack locking pin (C, Figure 14),
rotate the jack into the operating position (D), and install
the stabilizer jack locking pin fully through the top and
bottom holes in the jack and outrigger.
WARNING
Rollover Hazard
Failure to secure the stabilizer jack in the operating position
could cause the back of the light tower trailer to collapse,
resulting in death or serious injury. Always be sure to
secure the stabilizer jack in the operating position with the
jack locking pin.
4. Unfold the handle (E, Figure 15) of the stabilizer jack,
then turn clockwise (F) to lower the jack foot (G) until
firmly planted on the work site surface.
WARNING
Rollover Hazard
Stabilizer jacks must be supported by a flat, level solid
ground surface.
5. Repeat for the opposite outrigger and stabilizer jack.
To retract the outriggers:
1. Fully raise the stabilizer jack foot by turning the jack
handle counterclockwise.
2. Fold the handle.
3. Remove the stabilizer jack locking pin, rotate the jack
into the transport position, and install the stabilizer jack
locking pin fully through the top and bottom holes in the
jack and outrigger.
4. Lift the outrigger locking pin, and slide the outrigger in
until the pin locks the outrigger in the transport position.
5. Repeat for the opposite stabilizer jack and outrigger.
18
14
15

Fueling the Unit

WARNING
Fire Hazard
Attempting to fuel the light tower trailer with the engine
running could cause fire resulting in death or serious injury.
Always make sure the engine is shut down before adding
fuel to the fuel tank.
The light tower trailer is equipped with a single fuel tank
having a capacity of 45 gallons (170 L).
1. Unlock and open the fuel door (A, B, Figure 16) on the left
side of the unit.
2. Remove the fuel cap (C, Figure 16) and add fuel to
the tank. See General Fuel Information in the
Maintenance section for fuel recommendations.
Reinstall the fuel cap after adding fuel.
www.allmand.com

Publicité

Table des Matières
loading

Table des Matières