Disassembling The Mowing Unit; 6.6. Replacement, Setting And; Sharpening Of Mowing Blades; Storage - Eurosystems P130 Traduction Du Manuel D'origine

2) Is placed on the lower right blade mo-
vement plate (7); the same lubricator is
placed on the upper left blade movement
plate.
3 and 4) Are placed on the blade move-
ment bushes inside the grass protection
cover (8). To reach the latter, remove the
rubber guards (10 and 11) with a screw-
driver (9) that will be re-fitted after having
added grease.
6.5. DISASSEMBLING THE MOWING
UNIT
[ fig. 07A]
Procedure for disassembling the Mowing
unit:
Unscrew the screw (1) that connects the
blade movement plate (2) to the blade mo-
vement arm (3).
Unscrew the screw (4) that secures the
mowing unit (5) to the frame support (6).
Unscrew the screws (7) and (8) that se-
cure the bar protection tube (9) to the
mowing unit (5).
Perform the same operations on the left
side of the accessory.
At this point, you can disassemble the
mowing unit (5).
To reassemble the mowing unit onto the
frame, repeat the above mentioned opera-
tions in reverse order.

6.6. REPLACEMENT, SETTING AND

SHARPENING OF MOWING BLADES

Refer to the operation and maintenance
manual of the ESM Bar.

7. STORAGE

CARE!
Station the accessory/tool (with or
without the connected machine) on
stable ground.
DANGER!
It is COMPULSORY for the blade guard
(1) of [ fig. 05A] to be mounted when
storing the accessory.
Short or long term storage:
1. Clean the accessory properly;
2. Protect the bar and blade with an-
ti-corrosive and antioxidant substan-
ces.
3. Cover the accessory/tool with a
nylon or fabric cover;
EN-15