Protection Covers; Cleaning And Washing; Lubrication Double-Bladed Mowing Bar - Eurosystems P130 Traduction Du Manuel D'origine

6.2. PROTECTION COVERS

Before the engine is started each time
check that the lids and casings, tools and
accessories are fitted properly and are in
tip top condition.
INFORMATION:
Replace damaged guards before using
the machine!

6.3. CLEANING AND WASHING

Clean and wash the accessory/tool after
each use.
Cleaning:
It is possible to clean the accessory/tool
using compressed air.
CARE!
Under no circumstances remove the
protection lids on the machine.
Washing:
Carefully wash the contact surfaces
between the guides and blade sections
DANGER!
Do not use pressurised water to wash
the accessory/tool when connected
or in close proximity to the machine.
Pressure can damage the electrical
EN-14
system. Avoid excessive use of water
or the use of water near sensitive parts
such as the motor, batteries, labels, and
electrical systems.
6.4. LUBRICATION DOUBLE-BLADED
MOWING BAR [ fig. 07]
Every 4 hours of work, lubricate (with lu-
bricating grease resistant to compression,
or with food grade grease to be able to
mow food products) the blade drag bea-
ring using a grease gun (2).
Every 8 hours of work, lubricate (with lu-
bricating grease resistant to compression,
or with food grade grease to be able to
mow food products) the movement com-
ponents of the Mowing Bar using a grease
gun (1, 3 and 4).
The blade movement unit is supplied com-
plete with all its components.In the areas
(A, B and C) there is graphite grease to
lubricate the components that come into
contact with each other.
Position of the greasers:
1) Is located in the centre of the hub be-
aring support (6) of the right blade move-
ment arm; the same lubricator is placed
on the left.