Tool/Accessory Uncoupling; Cutting Height Adjustment; Preliminary Checks To Be Performed Before Every Machine Start-Up - Eurosystems P130 Traduction Du Manuel D'origine

CARE!
Once the accessory has been coupled,
lift the stand (1) completely turning the
handle (B) anticlockwise
5.2. TOOL/ACCESSORY
UNCOUPLING [ fig. 06, 6A-6C
• Turn off the machine's motor, turn the
handle (B) clockwise until the stand (1)
touches the ground. To facilitate the
release, perform a further complete
clockwise rotation of the handle (B).
• Make sure that the PTO lever [22] is
in the neutral
• Release the parking brake by mov-
ing the lever [25] into the position of
;
• Open the fixing hooks moving the le-
ver [26] into the position
• Exert pressure on the handlebars
from below upwards in such a way that
the front of the machine slides off the
tool.

5.3. CUTTING HEIGHT ADJUSTMENT

[ fig. 06D-6E]
CARE!
Never carry out adjustments with the
motor switched on.Always remove the
ignition key and/or the spark plug cap
before working on the accessory to pre-
EN-10
position;
;
vent sudden or unexpected starting.
CARE!
After stopping the accessory, leave the
hot surfaces to cool down for at least
15-20 minutes before approaching.
CARE!
Always wear gloves and safety shoes
and use proper equipment when adju-
sting the cutting height.
Adjust the cutting height according to
the requirements and the difficulty of the
ground by using the adjustment pads (1)
and (2).Proceed as follows: loosen nuts (3)
with standard key, lift or lower the pads (1)
and (2) to the desired position, then firmly
tighten the nuts (3).
CARE!
Do not completely remove the adjust-
ment bolts to prevent damage to the
blade.
5.4. PRELIMINARY CHECKS TO BE
PERFORMED BEFORE EVERY MACHINE
START-UP
When the working day begins, before
starting the machine carry out the follow-
ing checks: