Maintenance - Eurosystems P130 Traduction Du Manuel D'origine

DANGER!
Before entering the danger zone, wait
for all the machine's moving parts to
come to a standstill (at least ten sec-
onds from the stopping of the engine).
DANGER!
Wait for the hot parts of the machine to
cool down (at least 15-20 minutes).
DANGER!
To clean, use tools that are appropriate
according to the type of tool/accessory
that is being used (specific instructions
in the too o accessory user manual).
Pay attention to the cutting elements.

6. MAINTENANCE

In addition to observing the safety and
operational instructions it is just as impor-
tant to follow the following maintenance
instructions.
CARE!
Never carry out maintenance or clean-
ing operations with the engine on. Be-
fore working on the machine, always
remove the ignition key and/or spark
plug hood to prevent inadvertent or un-
expected starting.
EN-12
CARE!
After the machine has come to a stop
cool the hot surfaces down for at least
15 to 20 minutes before approaching it.
CARE!
Always wear gloves, safety footwear,
glasses and use adequate lid during
maintenance of knives and/or other
sharp parts.
CARE!
Do not carry out repairs that entail
welding, drilling, grinding etc. on struc-
tural components and safety devices.
Only use genuine Eurosystems parts. All
the other parts on the market must corre-
spond with the technical and quality requi-
sites specified by Eurosystems.