Operating In Other Conditions - Yamaha Motor VF150 Serie Manuel De L'utilisateur

Operation
1. Cooling water inlet
EMU40712
Procedure for shallow water cruising
1. Move the remote control lever to the
neutral position.
2. Push the " " (up) side of the power trim
and tilt switch to tilt the outboard motor
up slightly to the desired position.
WARNING! Using the power trim and
tilt switch on the bottom cowling while
the boat is moving or engine is on
could increase the risk of falling over-
68
1
ZMU08012
N
ZMU07034
N
ZMU06926
board and could distract the operator,
increasing the risk of collision with an-
other boat or an obstacle.
1
UP
1. Power trim and tilt switch
3. To return the outboard motor to the nor-
mal running position, push the "
(down) side of the power trim and tilt
switch to tilt the outboard motor down
slowly.
DN
1
1. Power trim and tilt switch
EMU41371

Operating in other conditions

Operating in salt water
After operating in saltwater, brackish water,
or water high in other minerals, flush the cool-
ing system with fresh water to minimize cor-
rosion and clogging of the cooling water
passages with deposits. Also, rinse the exte-
rior of the outboard motor with fresh water.
[EWM01851]
ZMU06986
"
ZMU06987