Checks After Starting Engine; Cooling Water - Yamaha Motor VF150 Serie Manuel De L'utilisateur

Operation
ON
OFF
OFF
4. Turn the main switch to the "
(start) position, and hold it for a maxi-
mum of 5 seconds.
ON
58
ZMU07031
ON
ZMU06927
START
ZMU07032
5. Immediately after the engine starts, re-
lease the main switch to return it to the
" (on) position. NOTICE: Never turn
"
the main switch to "
the engine is running. Do not keep the
starter motor turning for more than 5
seconds. If the starter motor is turned
continuously for more than 5 seconds,
the battery will be quickly discharged,
thus making it impossible to start the
engine. The starter can also be dam-
"
aged. If the engine will not start after 5
seconds of cranking, return the main
switch to "
then crank the engine again.
EMU36511

Checks after starting engine

EMU41361

Cooling water

Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the cooling water pilot hole shows
that the water pump is pumping water
through the cooling water passages.
TIP:
When the engine is started, there may be a
slight delay before water flows from the cool-
ing water pilot hole.
ON
START
ZMU06928
" (start) while
" (on), wait 10 seconds,
[ECM00193]