Using The Main And Dual Parts; Using The Metronome - Roland EXR-46 OR Manuel D'utilisation

r EXR-46 OR
Alternatively, press and hold one of the eight USER TONES
buttons (Main part) while pressing another USER TONES
button (Split part).
Note: You cannot assign Drum Kits to the Split part.
Note: You can also add a monophonic bass part ("Auto Bass") to
the Split part. See "Auto Bass*: status and volume" (p. 41).

Using the Main and Dual parts

(1) To play two sounds simultaneously, press the [DUAL] but-
ton.
DUAL
The icon appears and the EXR-46 OR now automati-
DUAL
cally selects a sound for the Dual part that complements the
sound assigned to the Main part.
You can also activate the Dual mode by holding down one of
the eight USER TONES buttons while pressing another. The
first USER TONES button's sound is then assigned to the
Main part, while the second sound is assigned to the Dual
part.
(2) Play a few notes on the keyboard.
To change the balance between the Main and Dual sounds,
proceed as follows:
(3) Hold down the [DUAL] button and use BALANCE
[ACCOMP] (decrease) or [KEYBOARD] (increase) to change
the Dual part's volume.
(4) To assign another sound to the Dual part, hold down the
[DUAL] button and proceed like for the Main part
(page 13).
Note: You cannot assign Drum Kits to the Dual part.
14

Using the metronome

You can switch on the metronome when practising a new song.
(1) Press the [METRONOME] button.
METRONOME
The icon appears in the display and you hear the metro-
nome sound.
(2) Press and hold [METRONOME] to select the Metro TS
function.
(3) Use the [–][+] buttons to set another time signature.
The possibilities are: 1/4~9/4, 1/8~9/8.
(4) Press another "big" button in the DATA ENTRY section to
leave this function.
(5) Press the [METRONOME] button again to switch the met-
ronome off.