Important Safety Information; General Information; General Safety Information - Ford 16A Three Phase Mode D'emploi

2

Important Safety Information

2.1

General information

The Ford Connected Wall Box has been developed, pro-
duced, tested and documented according to the relevant
safety regulations and environmental requirements that ap-
ply to your geographical area.
You must only use the wall box in a technically faultless
condition. Any malfunctions that adversely affect the safety
of persons or of the device must be immediately rectified by
a qualified electrician in accordance with applicable regula-
tions and warranty conditions. It is strictly prohibited to
modify, change or manipulate the device.
NOTE
Signalling in your vehicle may differ from that de-
scribed in this guide. Always read and observe the
vehicle manufacturer's user manual.
6
2.2

General safety information

WARNING
- You must comply with the locally applicable re-
quirements regarding electrical installations, fire
protection, safety regulations, and escape routes
at the intended installation location.
- Hazardous voltages are present within the cas-
ing.
- The Ford Connected Wall Box does not have its
own mains ON/OFF switch. The protective
devices installed in the power supply system are
therefore also used to disconnect the power sup-
ply.
- Inspect the wall box for visual damage before
installation and use. Do not use the wall box if it
appears to be damaged.
- Installation, electrical connection and initial op-
eration of the wall box must be carried out by a
qualified electrician.
- The screw-mounted unit cover may only be re-
moved by qualified electricians.
- Do not remove markings, warning symbols or
the type-label from the wall box.
- The charging cable may only be replaced by
qualified electricians and in accordance with the
installation manual.
- You are strictly prohibited from connecting
other equipment/devices to the wall box than
those for which the wall box was designed and
intended.
WARNING
- When not in use, store the charging cable in the
designated holder and lock the charging coupling
in the remote dock. Loosely wind the charging
cable around the remote dock making sure the
cable does not touch the floor.
- You must make sure that the charging cable
and coupling cannot be driven over, trapped and
are protected from all other hazards.
SKLJ98-10C823-BA
WARNING
- Immediately notify Customer Service if the wall
box, charging cable or the charging coupling are
damaged. Do not continue to use the wall box.
- Prevent the charging cable and coupling from
coming into contact with external heat sources,
water, dirt and chemicals.
- Switch off power at the circuit breaker before
installing or cleaning.
- Do not attach extension cables or adapters to
the charging cable.
- Never clean the wall box with a high-pressure
cleaner or similar.
- Switch off the power supply before cleaning the
charging sockets.
- The charging cable must not be subjected to
any strain during use.
- You must make sure that no one has access to
the wall box without reading this user manual
first.
- Make sure that the wall box temperature is
within its storage temperature limits when mov-
ing, transporting, or storing it.
- You are strictly prohibited from pulling the wall
box by its cable.
- The Ford Connected Wall Box must be connec-
ted directly to your home's mains connection; no
plugs and sockets must be used.
- You may only operate the wall box after profes-
sional installation.
WARNING
When transporting the Ford Connected Wall Box,
handle with care. Do not subject it to strong force
or impact, also do not pull, twist, tangle, drag, or
step on the Ford Connected Wall Box, to prevent
damaging it or any of its components.
Ford Connected Wall Box Operation manual