Briggs & Stratton 555700 Guide page 14

Oil Capacity:
Armature Air Gap
Compression ratio
Factory Timing
Starter battery requirements
Exhaust system requirements
Fuel requirements
Filter specs
Rev limiter specs
Torque Specifications:
Flywheel nut
Flywheel holder
Starter clutch tool
Cylinder Head
Connecting Rod
Crankcase Cover or Sump
Cylinder Head Plate (Fig. 1)
Rocker Arm Stud
Valve Cover
Spark Plug
Valve Lash (Cold)
Both Intake and Exhaust
• Measure when piston is between TDC or 22.76 degrees ATDC (Piston is down .103 in. or 2.62 mm)
Spark Plug
18-20 fl. oz. (.5-.6 liters)
.006/.014 in. (.15/36mm)
9.7 to 1
29.5 degrees BTDC
At least 12 Volt, 8 Amp Hour Rating is Recommended
50 mm x 57 mm flex coupling / 50/90 2-cycle canister muffler
98 Octane (RON)
GREEN Filter
7100 + 50 RPM
55 - 75 ft. lbs. (74.5 - 101 Nm)
Part #19372
Part #19244
180 - 220 in. lbs. (20 - 25 Nm)
90 - 110 in. lbs. (10 - 12 Nm)
95 - 125 in. lbs (11 - 14 Nm)
70 - 90 in. lbs. (8 - 10 Nm)
70 - 110 in. lbs. (8 - 12.5 Nm)
30 - 60 in. lbs. (3.5-7 Nm)
95 - 145 in lbs. (11-16 Nm)
.005 - .007 in. (.127 - .178 mm)
95 - 145 in lbs. (11-16 Nm)
Torque Specifications
TORQUE 2 ROCKER
ARM STUDS TO 70-110
TORQUE 2 SCREWS TO
IN. LBS. (8-12.5 Nm)
70-90 IN. LBS. (8-10 Nm)
Fig. 1 - Installing Cylinder Head Plate
FEELER GAUGE
50-70 IN. LBS.
Fig. 2 - Adjusting Valve Clearance
TORQUE TO
(6-8 Nm)