BONFIGLIOLI Active Energy Control Device Serie Guide De Démarrage Rapide page 96

4.8.1.2 Actual value parameters
No.
30 Configuration
1)
400 Switching frequency
2)
520 Fixed Percentage 1
2)
GB
Op. Mode Digital
530
1)
Output 1
651 Operation Mode
3)
700 Amplification
2)
2) 701 Integral Time
Operation mode of
800
2)
voltage controller
Reference DC-Link
801
2)
Voltage
Max. DC-Link Voltage
802
2)
Deviation
803 Max. Output Current
2)
804 Max. Feed Current
2)
805 Max. Feedback Current A
2)
94
AEC-relevant parameters
Description Unit
Hz
%
ms
V
V
A
A
Quick Start Guide AEC
Explanation
Selection of feedback method
Pulse width modulation
Setting of phase displacement between
output current and mains voltage via
input of I /I
react nominal
Selection of operation mode of digital
output 1. By default, it is set to "
Inv. Error Signal
Alternatively, you can also choose "
Inv. Flux-Forming finishe
Then, output S1OUT will signal that
synchronization was successful (can be
used, for example, as the start signal for
connected ACU frequency inverters).
Control of autostart behavior
Amplification for controller of internal
control circuit
Integral Time for controller of internal
control circuit
Set the operation mode. In the standard
software, "
1 Voltage Control
set
Input of reference value of DC link
voltage
Max. inverter output current; limits both
the feed-in current and the feed-back
current
Input of maximum feed-in current, the
mains unit may receive from mains
through the inverter
Input of maximum feedback current, the
mains unit may feed into the mains via
the inverter.
103
".
130
d".
" is
06/19