Resetting Unit To Factory Default Settings (All Models) - Miller Syncrowave 250 DX Manuel De L'utilisateur

4-18. Resetting Unit To Factory Default Settings (All Models)

1 Process Control
2 Amperage Control
3 Output Control
4 Start Control
1 2 3 4
(CE Nameplate)
1 2 4
3
5 Power Switch
To reset all welding power source functions
to original factory settings, turn power off.
Push and hold the Process, Amperage,
5
5
Output, and Start controls and turn On pow-
er. Hold switch pads for approximately 7
seconds (or until software version number
_ _ _ _ _ _-_clears meters).
OM-363 Page 45