Section 5 − Maintenance & Troubleshooting; Routine Maintenance; Blowing Out Inside Of Unit - Miller Phoenix 456 CC/CV Manuel Du Propriétaire
Masquer les pouces
Voir aussi pour Phoenix 456 CC/CV:
- Manuel de l'utilisateur (36 pages) ,
- Manuel de l'utilisateur (36 pages) ,
- Mode d'emploi (33 pages)
Table des Matières
Publicité
SECTION 5 − MAINTENANCE & TROUBLESHOOTING
5-1. Routine Maintenance
5-2. Blowing Out Inside Of Unit
OM-188 422 Page 24
Y Disconnect power
Replace
Damaged Or
Unreadable
Labels
before maintaining.
3 Months
Repair Or
Replace
Cracked
Cables
Clean
And
Tighten
Weld
Terminals
6 Months
Blow Out Inside
.
Maintain more often
during severe conditions.
Replace Cracked
Torch Body
Repair Or Replace
Cracked Cables
And Cords
Y Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
ST-801 718
Publicité
Table des Matières
