Arcam HDA SA30 Manuel page 27

SA30 Specifications
Continuous power output (0.5% THD), per channel
Both channels, 8Ω, 20Hz—20kHz
Both channels, 4Ω, at 1kHz
Harmonic distortion, 80% power, 8Ω at 1kHz
Analogue Inputs
ADC
Sample rate / bit depth
Phono Inputs
Input sensitivity at 1kHz (nominal)
Input impedance
Signal/Noise ratio (A-wtd)
Overload margin
Frequency response (ref. RIAA curve)
Line Inputs:
Nominal sensitivity
Input impedance
Maximum input
Frequency response
Signal/Noise ratio (A-wtd) 100W, ref. 2.1V input 112dB analogue direct, 106dB ADC / DAC
Digital Inputs
DAC
Frequency response
Total harmonics distortion + Noise
Signal/Noise ratio (A-wtd) ref. 0dBFS/100W
Supported sample rates Optical
Coaxial
Bit depth
130W
200W
0.002%
AK5552
192kHz / 32 bit
Moving Magnet (MM) Moving Coil (MC)
5mV 0.35mV
47kΩ + 200pF 470Ω + 1nF
80dB, ref. 5mVat 1kHz 80dB, ref. 0.35mV at 1kHz
21dB ref. 5mV at 1kHz 21dB ref. 0.35mV at 1kHz
20Hz – 20kHz ± 1dB 20Hz – 20kHz ± 1dB
1V
10kΩ
4.8Vrms
20Hz – 20kHz ± 0.2dB
ESS9038K2M
20Hz - 20kHz ± 0.1dB
0.0007%
113dB
32kHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz
32kHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, 192kHz
16-bit – 32-bit
Pre-amplifier output
Nominal/Maximum output level
Output impedance
Headphone output
Maximum output level into 600Ω
Output impedance
Load range
General
Mains voltage
Maximum power consumption
Low power standby consumption
Network standby consumption
Dimensions W x H x D (including feet, control
knob and speaker terminals)
Weight (net)
Weight (gross)
Supplied accessories
EN-25
800mV / 1.25V
240Ω
5Vrms
1Ω
16Ω – 2kΩ
110–120V or 220–240V, 50/60Hz
800W
0.5W
2W
433x100x323mm
10.7kg
13.8kg
Mains leads
Remote control
2 x AAA batteries
User Manual
2 x WiFi Antenna
Setup microphone
USB cable
All specification values are typical unless otherwise
stated. Arcam has a policy of continuous improvement
for its products. This means that designs and
specifications are subject to change without notice.
E&OE.
EN