Setup Menu; System Settings; Audio Settings; System Info - Arcam HDA SA30 Manuel

Setup Menu

The setup menu allows you to configure various aspects
of the SA30 integrated amplifier.
Entering Setup Menu
To enter the setup menu, press the key on the
remote control or front panel.
Navigating The Setup Menu
The setup menu can be navigated by using the remote
control or pressing the front panel keys that correspond
to the function shown on the display, as shown below.
To change a setting, simply turn the control knob left
or right.
DIRAC MUTE INFO DIRECT DISPLAY
HOME
Exit the menu and return to the
home display
UP Navigate to the previous menu
option
DOWN
Navigate to the next menu option
LEFT
Navigate left or move to the
previous field
RIGHT
Navigate right or move to the next
field
OK
Save the current setting and move
to next option
BACK
Save the current setting and exit
menu option

System Settings

Display
Allows the brightness of the front panel display to be
changed. The available settings are , and
The default setting is .
Dark Mode
Turns front panel display and status LED off.
Enable Input
Allows unused inputs to be removed from the input
selection list from the front panel. Inputs can still be
selected via remote control.
Timeout
This option allows you to choose the length of idle time
before the unit goes into standby. The available options
are Off, 20, 30 minutes, 1, 2 and 4 hours. The default
setting is 20 minutes.
System Code
Change the IR system code that the SA30 responds to
(either 16 or 19). The default code is 16.
Net Reset
Resets the network module to factory settings.
System Reset
Restores the SA30 to its factory default settings.
USB Update
Allows the SA30 to be updated via a USB stick. Refer
to the software release instruction for more details
available at www.arcam.co.uk.
OTA UPG
If enabled the SA30 will update automatically if left
powered on overnight or in network standby. If
disabled software updates need to manually installed.
Refer to the software release instruction for more details
available at www.arcam.co.uk.

System Info

Displays various system parameters including MCU,
Network and ARC software version numbers, IP address,
Friendly name, Googlecast name and serial number.
.
EN-20

Audio Settings

Dirac Curve
Specify which Dirac calibration is applied to each input.
Note: When Dirac is run for the first time the curve will
be applied to all inputs.
Balance
Turn the SA30 volume control knob left and right to
change the left and right channel balance, respectively.
Phones Ovr
Control whether or not the speaker outputs are
muted when a pair of headphones are connected to
the socket on the front panel. The default is
so the speakers and pre-outs will be muted when
headphones are connected.
PM Input
Specify which input is to be used in processor mode.
This mode can be assigned to most analogue inputs. In
this case, the SA30 output level is set to a fixed level. The
default setting is .
Note: The PHONO input cannot be selected as the
processor input.
PM Volume
Specify the required volume level for the processor
mode input. The default is volume is 30.
Max On Vol
Limits the maximum volume when the SA30 is switched
on or comes out of Standby. The SA30 comes on at this
stored volume setting if the last used (possibly very
loud) volume exceeds this value. It is stored in memory
and recalled each time the unit is powered up.