Publicité
Les langues disponibles
Les langues disponibles
Trial-fit the spruce strip, and ensure that it makes good contact with the underside of
the fuselage over its full length. This is important, as it will be impossible to insert the
fin (4) completely if the strip is fitted incorrectly.
The production process leaves an unwanted piece of foam at the nose of the
fuselage; remove this to provide space for the power cables attached to the SPEED
400 PLUS.
Cut a slot about 10 x 6 mm in size at the bottom of the fuselage for the servo leads to
pass through.
Use the spruce strip (2) to remove the unwanted material from the slot.
19
Publicité
