Publicité
Les langues disponibles
Les langues disponibles
Installing the RC system
Undo the servo output screws and prise off the original output arms. Set the servos to
centre from the transmitter (or use a servo tester). Cut down the output arms (24) as
shown and fit them on the servos. Press the servos into their recesses, and apply a
drop of cyano to the mounting lugs to secure them.
Fit the steel pushrods (7) and (8) in the snake outers, connect them to the servo
output arms (24) and secure the arms with the output screws. Glue the snake outer
sleeves (5) and (6) to the sides of the spruce reinforcement (2).
Hold the elevator at neutral, carefully mark the point where the elevator pushrod
crosses the elevator horn, and bend the end of the rod at right-angles at the marked
point.
24
Publicité
