Publicité
Les langues disponibles
Les langues disponibles
Glue the fuselage reinforcement (2) in the fuselage (1), taking care to keep it exactly
central, and push it firmly into place. Check that the spruce strip does not push the
fuselage out of shape.
Install the captive nut (3) using plenty of adhesive. Cut the elevator snake outer
sleeve (6) to a length of 440 mm and glue it in place, pressing it into position with a
screwdriver. Glue it to the side of the spruce fuselage reinforcement (2) at the front.
Cut off a wedge 2 mm wide from the fin (4), and glue the rudder snake outer sleeve
(5) and the horn (9) in place as shown. Glue the snake outer to the appropriate
channel only.
20
Publicité
