Publicité
Les langues disponibles
Les langues disponibles
Glue the aluminium sleeve (11) and the elevator horn (9) in place. Caution: do not
use activator when gluing the sleeve. The tailplane can now be attached to the
fuselage using the retaining screw (12); you will need to deflect the rudder to one
side to reach the screw.
Glue the nylon inserts (13) in place: fit the nylon screws (14) in the inserts first, so
that you can press them fully into their recesses.
Slide the SPEED PLUS motor unit into the fuselage from the front, pushing it back as
far as it will go. Fit the folding propeller on the motor shaft to check the position, then
secure the motor with a little glue applied to the front edge. The propeller should not
be fixed permanently until you have test-run the motor.
22
Publicité
