Publicité
Les langues disponibles
Les langues disponibles
Essential tools and adhesives
Balsa knife
Screwdriver
Side-cutters
Mini flat-nose pliers
Paper scissors
Cyano-acrylate glue
Cyano activator
Building instructions
Please read right through these building instructions before you start construction, so
that you gain a general understanding of the sequence of events. Before you start
work on a particular stage, lay out the parts required together with the tools and
adhesives. The components should be prepared as described in the instructions.
You will need a smooth, completely flat surface for assembling the model; a layer of
foam on the building board will help to prevent damage to the foam surfaces. Use
cyano-acrylate glue ("cyano") with activator as adhesive for all joints unless stated
otherwise. Joints are best made by applying cyano to one surface, and spraying the
mating surface with activator. Please take particular care to avoid cyano getting onto
your hands and the surfaces of the model.
Caution: cyano-acrylate adhesives must not be allowed to come into contact
with any part of your body, and in particular not with the eyes. We therefore
recommend that you wear protective goggles.
Keep the adhesive in a safe place, well out of the reach of children.
On no account use Styrofoam cyano-acrylate ("foam cyano"), white glue (PVA
wood glue) or epoxy resin adhesives. These glues do not produce strong joints
between any of the kit materials and the SOLIDPOR high-density foam.
Fuselage and tail
Locate the channel for the spruce fuselage reinforcement (2) and use a balsa knife to
continue it full-length. Tip: simply slit the material with the balsa knife, then push out
the unwanted SOLIDPOR material using the spruce strip (2).
Order No. 980
Order No. 810
Order No. 5821
Order No. 953.150
18
Publicité
