Additional Functions; Access Protection; System Configuration; Access Code Input - Ecolab MULTRONIC Notice Technique
Appareil de mesure et de régulation
Masquer les pouces
Voir aussi pour MULTRONIC:
- Manuel technique (77 pages) ,
- Mode d'emploi (45 pages) ,
- Manuel technique (40 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9
Additional functions
9.1
Access protection
The access code function can be used to protect the set configuration data and parameters of
the Multronic against unauthorised changes. The access code is a four-digit, alphanumerical
string of characters that are requested every time the setting menu is accessed.
The settings for the access code are in the system configuration.
9.1.1
System configuration page 1
The access code can be entered once the on setting in the system configuration has been
acknowledged. The input mask for the access code is displayed automatically.
9.1.2
Access code input
Once the set access code has been adopted through operating ENTER, the system
configuration menu is displayed again.
417101163_Multronic.doc
Settings
off:
The setting menus are not protected by
access code.
on:
The setting menus are protected by
access code.
On (no cal.):
The setting menus are protected by
access code apart from the calibration.
The last access code that has been assigned
is automatically displayed. This access code
can
be
changed.
respective positions can be changed with the
↑ or ↓ keys. The position that is to be
changed can be accessed with the cursor
through operating the ←→ keys.
- 71 -
The
values
of
the
Rev: 5.07-08
Publicité
Table des Matières
