Safety; Safety Instructions; Pointers; Important - Ecolab MULTRONIC Notice Technique

2

Safety

2.1

Safety instructions

The unit has been built and tested in accordance with the relevant protective measures for
electronic units and was free of safety defects when it left the factory. To ensure that this
remains the case and to guarantee safe operation, it is essential that the user observes the
instructions and warnings contained in this manual. If there is any cause to suspect that the
unit can no longer be operated free of hazard, the unit should be shut off and secured against
inadvertent operation.
It is the case when:
- The unit shows visible signs of damage.
It appears that the unit is no longer functioning properly.
-
The unit has been stored for lengthy periods under unfavourable conditions.
-
CAUTION
ATTENTION
NOTE
2.2

Pointers

In this manual, the CAUTION, ATTENTION, IMPORTANT and NOTE pointers have the
following meanings:
CAUTION
ATTENTION

IMPORTANT

NOTE
2.3

Special safety information for maintenance and repair work

CAUTION
IMPORTANT
417101163_Multronic.doc
The unit and its associated accessory components (e.g. electrodes, recording units etc.)
must be installed in accordance with the relevant safety provisions.
The installation site must be chosen such that the housing is not exposed to any major
mechanical loadings.
Prior to starting-up, it is essential to check that all parameters have been correctly set.
This heading is used if imprecise or non-adherence to operating instructions, work
instructions, prescribed work procedures and the like can lead to injury or accident.
This heading is used if imprecise or non-adherence to operating instructions, work
instructions, prescribed work procedures and the like can lead to the device being
damaged.
Is used when special attention is required when for handling the equipment.
This heading is used if a special feature is being pointed out.
Electrical repair work may only be executed by licensed electricians (safety rule of the
Accident Prevention & Insurance Association VB G and ZH 1/11 [Germany])
When opening covers or removing parts, except for when this is possible without tools, live
wires/parts could be exposed.
Connector points may also be live with electricity.
Only original replacement parts may be used for repairs.
- 47 - Rev: 5.07-08