Start-Up; Initial Operation/Change Or Repositioning Of Measurement Modules Logo; Logo; Configuration Error - Ecolab MULTRONIC Notice Technique

6

Start-up

6.1

Initial operation/change or repositioning of measurement modules Logo

6.1.1

Logo

6.1.2

Configuration error

6.1.3

Configuration menu

6.2 Start up
ATTENTION
NOTE
6.2.1 Logo
417101163_Multronic.doc
Before switching on the mains voltage, check that the mains voltage matches with the
mains voltage listed on nameplate.
Once the operating voltage has been applied the device requires around 5 seconds for the
transient phase. Stable measured values can only be displayed after the transient phase.
Once the operational voltage has been
applied, the Multronic logo with the program
version is displayed for 5 seconds.
Upon the initial operation of Multronic or
when measurement modules are
repositioned, the system displays a
configuration error instead of the
measurement screen. You have to
acknowledge this error with the ENTER key.
Once the message "Configuration error" has
been acknowledged the configuration menu
opens. You can configure Multronic from this
menu (see section 7.1.4.1). Choose 'operator
level' from the menu to return to the initial
menu for the unit.
Once the operational voltage has been
applied, the Multronic logo with the program
version is displayed for 5 seconds.
- 55 - Rev: 5.07-08