Anchor Strap; Service Access - Jacuzzi PURE AIR II Amiga Instructions D'installation Et De Fonctionnement

ANChor StrAP

Drop-In Bath units are equipped with metal anchor straps.
These straps can be used to secure the unit to the floor or
sub-floor to reduce movement after installation. If mortar
or similar anchoring material is used, these straps are not
necessary.
WArNINg: ALL foam feet must contact the floor. Anchoring
straps and/or other anchoring materials will not properly
anchor unit if ALL foam feet are NOT in contact with a level
floor. Operating a unit improperly installed may cause
irreparable damage to the unit.

SErVICE ACCESS

For partially or fully sunken installations, allow for access
to service connections. It is the installer's responsibility
to provide sufficient service access. The recommended
minimum dimensions allowable for service to the bath are
shown in the "Service Access" illustration below.
Provide adequate ventilation for cooling and to supply
sufficient air for the blower. Do not insulate this area or
around blower.
SErVICE ACCESS rEQUIrED
FRONT
12"
18"
Jacuzzi ® Comfort Pure Air II Bath: Installation and Operation
™
Blower
12"
18"
PREFERRED
ACCESS
ALTERNATE
ACCESS
ANChor StrAP
SErVICE ACCESS (Non-skirted corner bath)
FRONT
Right-hand unit shown
A = Preferred access
B = Acceptable alternative if Access A is not possible
NotE: Left hand unit access is on the opposite side (mirror image)
Page 1
Nail or screw
through anchor
strap into floor
Anchor strap
Floor
20"
18"
24"
BM62000D • February 2008