Sawing Off Small Branches; Sawing Off Larger Branches; Sawing Off Parts; Maintenance / Cleaning - Grizzly AKS 1820 T Lion-Set Traduction De La Notice D'utilisation Originale

GB

Sawing Off Small Branches

Set your saw cut of smaller branches
(Ø 0-8 cm) from top to bottom, as illus-
trated.
Be aware of early breaking of the branch
if you have underestimated the size and
weight.
Be completely aware of the falling cut
material.

Sawing Off Larger Branches

For controlled sawing of larger branches
(Ø 8-20 cm), first select a relief cut (see
cutting a).
This is made from below. Saw a notch in
the lower third of the branch.
The actual length cut (see cutting b) is
again made from the top, as far as possi-
ble in line with the first cut so that the two
cuts meet.
74

Sawing Off Parts

For large/long branches, sawing off in parts
is recommended (see cutting a, b, c).
This is the only way to safely ensure the
point of impact of the cut material.
Clear away from the area in which you are
standing any parts that have already been
cut and are lying on the ground.

Maintenance / Cleaning

Ask our service centre to carry out
any work that is not described in
these instructions. Use only origi-
nal parts.
Turn off the appliance and, before
doing any servicing, remove the
battery.
When handling the cutting equip-
ment, wear safety gloves. In this
way, you avoid cutting damages.

Cleaning

Do not use cleaning agents or sol-
vents. You may otherwise irrepara-
bly damage the appliance.
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.