Operation; Switching On And Off - Grizzly AGS 72-2 Lion Traduction De La Notice D'utilisation Originale

GB
while charging it and make sure
that the safety key (
been removed.
There is a risk of injury from
electric shock.
Ensure that the equipment is
charged for no longer than
3-5 hours without interruption.
The battery and equipment could
be damaged and they consume
energy unnecessarily in case of
longer charging time. Overcharg-
ing invalidates the guarantee.
• The machine must be supplied only
with SELV appropriate the mark on
machine.
• Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short
periods in succession.
• Use the charger supplied to charge the
Li-ion battery installed in the equipment.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
To check the state of charge:
To display the state of charge of the bat-
tery, press the "Test" button on the state of
charge indicator (
Battery full:
Red + yellow + green light up
Battery half full:
Yellow + red light up
Battery empty:
Red lights up
92
6) has
2).:
1. Remove the safety key (6).
2. Connect the charger cable plug
(26) with the charger socket on
the tool (10).
3. Connect the power supply unit
( 25) to a socket.
The charging indicator (7) lights
up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging time
is max. 3 – 5 hours.
4. After the recharging process
is completed, first unplug the
charger from the wall outlet, and
then remove the charger cable
plug from the tool.

Operation

Keep to noise abatement regula-
tions and other by-laws.

Switching on and off

1. Remove the blade guard (14/17)
before switching the unit on.
2. Insert the safety key (6) into the
device.
3. To switch on, hold the switch lock
(4) depressed and operate the
on/off switch (8). Then release
the switch lock.
The equipment runs at top speed.
4. In order to switch off, let go of
the on/off switch (8).
After switching the unit off, the
blades take a short time to stop
moving. Let the blades come to a
complete standstill. Do not touch
the moving blades and do not try to
stop them moving. Injury hazard!