Charging Process; Operation; Switching On And Off - Grizzly AGS 72-3 Lion-Set Traduction De La Notice D'utilisation Originale

Charging process

Do not expose the battery to
extreme conditions such as heat
and impact. There is a risk of
injury from leaking electrolyte
solution! In case of contact,
rinse with water or neutraliser
and consult a doctor if contact
has occurred with eyes etc.
Charge the battery only in dry
areas.
Do not switch on the device
while charging it. The safety key
( 6) must be during the load-
ing process plug.
There is a risk of injury from
electric shock.
Ensure that the equipment is
charged for no longer than 3 hours
without interruption. The battery
and equipment could be damaged
and they consume energy unnec-
essarily in case of longer charging
time. Overcharging invalidates the
guarantee.
• The machine must be supplied only
with SELV appropriate the mark on
machine.
• Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short
periods in succession.
• Use the charger supplied to charge
the Li-ion battery installed in the equip-
ment.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
To check the state of charge:
To display the state of charge of the bat-
tery, press the "Test" button on the state of
charge indicator (
Battery full: Red + yellow +
green light up
Battery half full: Yellow + red
light up
Battery empty: Red lights up
1. The safety key (6) must be du-
ring the loading process plug.
2. Connect the charger cable plug
(26) with the charger socket on
the tool (10).
3. Connect the power supply unit
( 25) to a socket.
The charging indicator (7) lights
up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging
time is max. 3 hours.
4. After the recharging process
is completed, first unplug the
charger from the wall outlet, and
then remove the charger cable
plug from the tool.

Operation

Keep to noise abatement regula-
tions and other by-laws.

Switching on and off

1. Remove the blade guard (14/17) be-
fore switching the unit on.
2. Insert the safety key (6) into the de-
vice.
GB
2):
95