Operation; Insert/Remove Battery; Attaching/Setting The Shoulder Strap; Adjusting The Telescopic Arm - Grizzly AKS 1820 T Lion-Set Traduction De La Notice D'utilisation Originale

GB
The cordless pruner is equipped with an
oil automatic system. As soon as the mo-
tor is speeded up, the oil also flows faster
to the chain bar (
Before starting work, check the oil level
in the oil automation system (see "Opera-
tion").
Filling up with chain oil:
• Check the oil fill level in the oil level
inspection window (23) and regularly
top up with chain oil.
• Use bio chain oil ; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center.
• If you have no bio chain oil available,
use chain lubrication oil with low ad-
hesive additive content.
1. Unscrew the oil fill cap (22) and fill up
with chain oil.
2. Wipe off any spilled chain oil and
close the cap again.
Note that the saw can re-oil.

Operation

When working with the device
wear suitable clothing, work
gloves, protective headgear
and hearing protection and firm
work boots. Prior to each use it
must be ensured that the device
is operative. The on/off switch
and the safety switch must not
be locked. The motor must be
switched off when the switch
has been released. Do not use
the device if a switch is dam-
aged.
72
2).
Observe noise control and local
regulations.

Insert/remove battery

1. To insert the battery (16) into the de-
vice, push the battery along the guide
rail into the device. It locks into place
audibly.
2. To remove the battery (16) from the
device, press the release button (17)
on the battery and pull the battery out.
Attaching/setting the
shoulder Strap
1. Attach the carabiner hook of the shoul-
der belt (26) to the carrying eye (15)
on the telescopic arm of the device.
2. Set the belt length in a way that the
carrying eye (15) is at hip height.
3. You can also adjust the height of the
carrying eye (15) on the telescopic
arm after loosening the hex socket
head screw (15a).
Adjusting the Telescopic
arm
The telescopic arm (10) can be infinitely
adjusted using quick release (11).
1. Push the lever (11a) forward as
shown in the illustration then push and
pull to adjust the handle length.
2. Pull back the lever (11a) and so fix
the desired working length of the tel-
escopic arm.
3. If the lever (11a) loosens, tighten the
Allen screw (11b) using the wrench
(12).