7.6 Log Placement - Napoleon GRANDVILLE BGD36CFNTR Manuel D'installation Et D'utilisation

7.6 log placement
WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
PHAZER TM logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A. Place the back log (#1) onto the log support tray
and in front of the tabs. The tabs maintain an
air space between the log and fi rebox back to
facilitate combustion air fl ow. Ensure that the back
of the log rests against the brackets on the back
wall of the fi rebox.
C. Position the front right log just behind the grate
lining up the holes in the bottom with the studs
located on the log support.
4
E. Line up the square hole in the right crossover
with the square post located on the right side of
log and install as shown.
G. Install the glowing embers and charcoal embers, refer to the "GLOWING EMBERS" AND "CHARCOAL
EMBERS" sections for detailled installation instructions.
H. Reinstall the door and safety screen, refer to the "SAFETY SCREEN & DOOR REMOVAL / INSTALLATION"
section for detailled installation instructions.
1
1 3
2
5
1
3
2
2
B. Move the charcoal strip into position lining
up the holes in the bottom with the studs
located on the burner on the burner. Ensure
strip sits fl at on the burner.
4
2
D. Move the left log into position lining up the hole
in the bottom with the stud on the left side of
the log support.
6
4
2
F. Line up the rectangular hole in the left crossover
with the rectangular post located on the left
side of log and install as shown.
fi nishing
1
1
3
5
1
3
39
W415-1345 / D / 05.01.17
EN